HVAC Service Plans

• Turn on the humidistat and test the humidifier
• Replace the humidifier pad
• Clean the humidifier reservoir
• Check solenoid valves
• Check the interlock to the fan
• Clear and test drain operation
• Check humidistat operation
• Check the humidifier fan

• Check:
  • Thermostat operation
  • Fan relay contacts
  • Blower operation
  • Belts
  • High- and low-pressure switches
  • All wiring connections
  • System operating pressures
  • Emergency auxiliary heat
  • Expansion valve
  • Evaporator
  • Condenser coil
  • Compressor amperage
  • Drain line and condensate pump
  • Any sediment from the condensate line
  • Reversing valve operation
  • Defrost control and operation
  • Refrigerant level
• Level and calibrate the thermostat if necessary
• Lubricate the fan motor and bearings if necessary
• Clean the motor and fan if necessary
• Identify the AC electrical circuit on the panel

Adding or adjusting refrigerant and repairing refrigerant leaks are not part of this preventative maintenance plan.

Heat pump systems are an additional $85 trip charge for the second annual cleaning if requested.

• Check/adjust:
  • Operation of safety limit controls
  • Gas piping to furnace
  • Thermostat operation
  • Burner assembly input
  • Automatic gas valve operation
  • Wiring connections
  • Manifold gas pressure
  • Pressure switches and vent blower
  • Any elevated carbon monoxide levels
  • Pilot light
  • Flame rectification
  • Combustion ventilation air adequacy
  • Draft hood
• Inspect the burner and clean if required
• Examine the vent connector and inspect the venting system
• Clean the equipment exterior
• Measure stack (flue) temperature

• Check/adjust:
  • Operation of safety limit controls
  • Gas piping to furnace
  • Thermostat operation
  • Burner assembly input
  • Automatic gas valve operation
  • Wiring connections
  • Manifold gas pressure
  • Pressure switches and vent blower
  • Any elevated carbon monoxide levels
  • Pilot light
  • Flame rectification
  • Combustion ventilation air adequacy
  • Draft hood
• Inspect the burner and clean if required
• Examine the vent connector and inspect the venting system
• Clean the equipment exterior
• Measure stack (flue) temperature

• Check:
  • Proper voltage
  • Temperature drop across the coil
  • Contacts and relays
  • Safety of the system
  • Proper refrigerant charge
  • Electrical connections
  • Blower assembly
  • Motors
  • Vibration noise
  • Condensate pump
  • Indoor coil (cleaning at additional charge)
  • Condensate drain
  • Visible leaks
• Clean filters (replacement at additional charge)
• Clean the condenser coil
• Level the condenser

Heat pump systems are an additional $85 trip charge for the second annual cleaning if requested.

• Check/adjust:
  • Proper voltage
  • Temperature drop across the coil
  • Pulleys and belts
  • Contacts and relays
  • Safety of the system
  • Proper refrigerant
  • Electrical connections
  • Blower assembly
  • Motors
  • Vibration noise
  • Condensate pump
  • Indoor coil (cleaning at additional charge)
  • Condensate drain
  • Visible leaks
  • Standard thermostat
• Lubricate all moving parts
• Clean filters (replacement at additional charge)
• Clean the condenser coil
• Level the condenser

Humidifiers, electronic air cleaners, UV systems, programmable thermostats, all types of dampers and other accessories are not included unless otherwise stated.